- The laser cutter may only be used by registered students, teachers and ETSA staff.
- Work outside of the degree courses will NOT be admitted.
- ETSA teaching and non-teaching staff who wish to use the laser cutting machine must request authorisation from the Director's Office with a brief explanation of the work to be carried out, this being limited to teaching work.
- The calendar and timetable of the laser cutter will be published on the website and on the notice board of the Taller de maquetas. No work will be carried out outside these hours.
- To book the use of the laser cutter, the instructions published on the website must be followed. A file must be created with the specifications set out there and then request the review of the files from the technical staff in charge of the Taller.
- The appointment will be reserved by email, it will be answered and an appointment will be made in order of entry.
tallmaq@gmail.com
- Follow the instructions published on the website or posted on the wall of the room and perform the steps according to the instructions. It is advisable to familiarise yourself with the instructions prior to the time reserved for use. In this way, you will be able to be totally autonomous and make the most of the time you spend using it.
- If you have any doubts, please consult the technical staff in charge of the Taller.
- The responsibility for the use of the machine and the execution of the work within the established timetable, as well as the result achieved, lies exclusively with the USER.
- The estimate of the time reserved for the execution of the work by the technicians for booking an appointment is for guidance only, provided that the work to be carried out is not subsequently modified. If there are time differences in the execution of the work that can be attributed to this reason, they will not be considered a justifiable cause for delay.